SmartTrunk Systems ST-9116 - Channel Power Selection; TX Sub Audio Signaling

SDRe Programming Software
Revision V1.0
P a g e | 68
Figure 84: Channel TX information
Once selected the right parameter, press [Ok] to save it or [Cancel]
to exit.
5.5.1.5. TX sub Audio Signaling:
Shows the CTCSS or DCS information for the current channel.
Click on the side arrow then select a different one if you want to
change it.
Once selected the right parameter, press [Ok] to save it or [Cancel]
to exit.
5.5.1.6. Channel Power selection
Shows the current power level assigned to the channel.
To change it, press on the side arrow then choose your desired
level.
Figure 85: Channel Power selection
Once selected the right parameter, press [Ok] to save it or [Cancel]
to exit.