SDRe Programming Software
4.3.1.7. Repeater Power Save mode:
In solar powered sites, it is very important to reduce the quiescent
current saving battery.
Click on the side arrow to select the proper power save mode:
Disabled: No power save functions
Normal: All internal resources are powered down, but the
receiver is all time powered on getting immediate reaction to any
call request.
Eco Mode: is an extreme power save, where all circuitry is
powered down, getting the receiver on only 100mSec by 300Msec
off. On this mode, the reaction may demand about 500msec to
recognize a call request, but the power saving efficiency is very
high.
4.3.2. Ethernet/IP configuration:
On this tab, you can program the parameters required for set the
repeater into an IP network environment.
To Next Page
Loading...