SmartTrunk Systems ST-9116 - RX Frequency; RX Sub Audio Signaling; TX Frequency

SDRe Programming Software
Revision V1.0
P a g e | 67
Figure 82: Channel tag
Once selected the right parameter, press [Ok] to save it or
[Cancel] to exit.
5.5.1.2. RX frequency:
Shows the RX frequency for this channel. You can edit it by direct
typing over the field.
Figure 83: Channel RX information
Once selected the right parameter, press [Ok] to save it or [Cancel]
to exit.
5.5.1.3. RX sub Audio Signaling:
Shows the CTCSS or DCS information for the current channel.
Click on the side arrow then select a different one if you want to
change it.
Once selected the right parameter, press [Ok], press over to save
it or [Cancel] to exit.
5.5.1.4. TX frequency:
Shows the TX frequency for this channel. You can edit it by direct
typing over the field.