SDRe Programming Software
7. Writing a radio file
Once you get a program into your programming software ready to
upload to a repeater, you must connect the device to the USB port on
your computer or remotely through a TCP/IP network, then you can
use the shortcut in the quick access bar or you go through
[Repeater] then click on [Write Repeater]. F3 key on your computer
keyboard can be used as a shortcut also.
Figure 94: Accessing to write the repeater
Once you press on [Write Repeater], the information stored in the
programming software will be uploaded to your repeater automatically.
As soon as the process starts, a progress bar will let you know the
process ongoing.
Figure 95: Writing to the repeater progress bar
As soon as the process ends, a pop up screen will notify the success
process.
To Next Page
Loading...