C
HAPTER
5
| Operation Mode
Logging In
– 52 –
LOGGING IN
It is recommended to make initial configuration changes by connecting a
PC directly to one of the Wireless Broadband Router's LAN ports. The
Wireless Broadband Router has a default IP address of 192.168.2.1 and a
subnet mask of 255.255.255.0. If your PC is set to “Obtain an IP address
automatically” (that is, set as a DHCP client), you can connect immediately
to the web interface. Otherwise, you must set your PC IP address to be on
the same subnet as the Wireless Broadband Router (that is, the PC and
Wireless Broadband Router addresses must both start 192.168.2.x).
To access the configuration menu, follow these steps:
1. Use your web browser to connect to the management interface using
the default IP address of 192.168.2.1.
2. Log into the Wireless Broadband Router management interface by
entering the default user name “admin” and password “smcadmin,”
then click Login.
N
OTE
:
It is strongly recommended to change the default user name and
password the first time you access the web interface. For information on
changing user names and passwords, see “Administration Settings” on
page 99.
Figure 20: Logging On
To Next Page
Loading...
Need help?
General
