-32-
PS##-OMM0003-A
■[F 5] Setting of display resolution
This function is to change the pressure display digit.
The flickering on the display can be eliminated.
<Operation>
Press the
or button in function selection mode to display [F 5].
Press the
button.
Move on to setting of display resolution.
Press the button to set.
Return to function selection mode.
Setting of [F 5] display resolution completed
∗: Not selectable depending on selected pressure unit.
The display resolution selectable unit is MPa (only for ISE), kPa (only for ZSE), bar and psi.
("bar" and "psi" are selectable only for models with the unit conversion function.
See [F 0] Unit conversion function on page
25.)
Setting of display resolution
Press the
or button to select display resolution.
To Next Page
Loading...
Need help?
General
