SMC Networks ZSE80(F)

-34-
PS##-OMM0003-A
■[F 8] Setting of auto-preset
When hysteresis mode is selected, this function can calculate a optimum pressure value automatically
based on the on-going operation.
<Operation>
Press the
or button in function selection mode to display [F 8].
Press the
button.
Move on to setting of auto-preset.
Press the
button to set.
Return to function selection mode.
Setting of [F 8] auto-preset completed
Press the
button during measurement mode to set the pressure.
Then press the
button again to change the set pressure when the display is blinking.
Setting of auto-preset
Press the
or button to select auto-preset.