-15-
PS##-OMM0003-A
Mounting and Installation
■Installation
○Mounting
•Mount the optional bracket and panel mount adapter to the Pressure switch.
•When the Pressure switch is to be mounted in a place where water and dust splashes occur, insert a tube
(O.D φ4, I.D φ2.5) into the air-relieving port of the Pressure switch.
○Mounting by bracket
•Fix the bracket to the Pressure switch with the set screws M3×5L (2 pcs.) supplied.
•Apply a tightening torque of 0.98 Nm or less.
<Rear piping>
<Bottom piping>
To Next Page
Loading...
