10 / 58
production of hollow articles - Requirements for design and construction.
• EN ISO 12100-1 - Safety of machinery - basic concepts, general principles for design:
terminology and methods.
• EN ISO 12100-2 - Safety of machinery - basic concepts, general principles for design:
technical principles and specifications.
• EN 292-2 A1 - Safety of machinery - basic concepts, general principles for design: technical
principles and specifications.
• EN 294 - Safety of machinery - Safety distances to prevent danger zones from being
reached by the upper limbs.
• EN 60204-1 - Electrical Equipment of Machines.
• EN 418 - Emergency stop.
• EN 349 - Safety of machinery - Minimum gaps to avoid crushing of parts of the human body.
• EN 1050 - Safety of machinery - Risk assessment.
• EN 811 - Safety of machinery - Safety distances to prevent danger zones from being
reached by the lower limbs.
• EN 894 -1 - Safety of machinery - Ergonomic requirements for the design of displays and
control actuators - part 1: human interaction with displays and control actuators.
• EN 894-2 - Safety of machinery - Ergonomic requirements for the design of displays and
control actuators - part 2: displays.
• EN 894-3 - Safety of machinery - Ergonomic requirements for the design of displays and
control actuators - part 3: control actuators.
• EN 953 - Safety of machinery - General requirements for the design and construction of
fixed and movable guards.
• prEN 50099-1 - Safety of machinery - Signalling and marking principles - part 1: visual,
audible and tactile signals.
1.4 REMARKS ON GENERAL SAFETY
The operator, before starting to work with this machine, must have acquired enough knowledge
on the location, function of the controls, characteristics of the machine, and must have read this
manual in all its entirety.
The employer must see to it that its personnel is informed on the following topics relative to the
safe usage of the machine:
• Accidents risks.
• Devices meant for the safety of the operator.
• General accidents prevention rules as provided by international directives and by the laws
of the country of destination of the machines.
It is necessary to comply to the following general precautions:
• Do not install the machine in areas posing a risk of explosion or fire.
• Do not temper with, remove or modify the safety devices; in such cases SMIPACK S.p.A.
declines any responsibility on the safety of its machines.
• Do not modify parts of the machine to install other devices without prior authorization by
SMIPACK S.p.A.; in case of unauthorized modifications the former will not be held
responsible for any possible consequences.
• Do not operate the machine in automatic mode with the fixed or mobile protections removed.
• Do not open the fuse blocks with the mains on.
• Do not intervene on switches, valves and sensors without authorization.
• Do not intervene on the moving parts even without the aid of objects or tools.
• Do not manually oil or grease any moving part.
• Before carrying out any work on the electrical installation, ensure that the voltage has been
disconnected.
• After an adjustment or security operation, restore the state of the machine with active
protections.
To Next Page
Loading...
