29 / 58
Use and maintenance manual BP700AR/310
ENGLISH
6. MAINTENANCE AND REPAIRS
ATTENTION!
Before begining any type of maintenance operation indicated in this chapter, unless
otherwise required, switch off the machine, switch voltage off acting on the main
switch, pull out the power supply cable from the mains and disconnect the tube that
feeds the pneumatic plant.
6.1 NATURE AND FREQUENCY OF MAINTENANCE CHECKS AND
OPERATION
Tab. 6.1.1
DAILY MAINTENANCE CHART (12 HOURS OF WORKING)
INFEED
CONVEYOR BELT
CLEAN BOTH THE CONVEYOR BELT AND THE GUIDES WITH SOFT
CLOTHS AND HOT WATER
SEALING UNIT
CLEAN THE BLADE WITH COMPRESSED AIR
REMOVE THE RESIDUES OF FILM STUCK ON THE CONTRAST
PROTECTIONS
CLEAN WITH SOFT CLOTHS AND WARM WATER
MAKE SURE THAT THE SAFETIES ARE WORKING CORRECTLY
GENERALCLEANING
TURN OFF THE MACHINE VOLTAGE
USE WARM WATER WITHOUT PRESSURE AND MAKE SURE YOU DO NOT
DIRECTLY SPRINKLE ON THE ELECTRIC AND ELECTRONIC
COMPONENTS
CAUTION! DO NOT LEAVE WATER RESIDUALS ON THE MACHINE
DRY THE MACHINE WITH LOW AIR PRESSURE
USE SOFT CLOTHS TO DRY THE MACHINE IF IT IS STILL WET
Tab. 6.1.2
WEEKLY MAINTENANCE CHART (60 HOURS OF WORKING)
SEALING UNIT
MAKE SURE THAT THERE ARE NO BREAKAGE ON THE CUTTING BLADE
ELECTRIC
COMPONENTS
OPEN THE SAFETY DOOR ON THE MACHINE AND VACUUM THE
DEPOSITED DUST
CONVEYOR BELT UNIT
MAKE SURE THAT THE BELT IS NOT DAMAGED AND THAT IT IS
PERFECTLY TENSIONED
REEL HOLDER
MAKE SURE THAT THE REEL HOLDER IS MOVING CORRECTLY
CLEAN THE ROLLERS WITH A DRY CLOTH
PUSHER DEVICE UNIT
MAKE SURE THAT THE PUSHER DEVICE IS SLIDING PROPERLY
CHECK THE PNEUMATIC PARTS
INFEED CONVEYOR
BELT
CLEAN BOTH THE CONVEYOR BELT AND THE GUIDES WITH SOFT
CLOTHS AND HOT WATER
To Next Page
Loading...
