Snap-On P1000 - AC Power Supply; Technical Specifications

General Information Technical Specifications
4
The Battery Status Indicator LED (located next to the power supply jack) indicates
battery status.
2.2.3 AC Power Supply
The diagnostic tool can be powered from a standard AC outlet using the AC power
supply. The AC power supply converts alternating current (AC) to direct current
(DC) to power the diagnostic tool. The connector on the end of the output cable of
the AC power supply connects to the AC power supply jack on top of the diagnostic
tool. Use only the AC power supply provided.
IMPORTANT
Never connect the AC power supply to the diagnostic tool when the
diagnostic tool is communicating with a vehicle.
2.3 Technical Specifications
Battery Status LED Description
Green - battery is fully charged, or the diagnostic tool is being
powered by the AC power supply.
Red - battery is charging
Amber - indicates a battery issue. This is usually caused by
excessive battery temperature (above 104°F/40°C), which
disables charging. Allow the diagnostic tool to cool down before
continuing operation.
Item Description / Specification
Touch Screen Resistive Touch Panel
Display
5.6 inch diagonal, LCD TFT
640 x 480 resolution
24 bit color
Battery Pack
Rechargeable lithium-ion battery pack
Approximately 3 hour run time
Approximately 5 hour charge time
Operating System SMX
Processor Motorola
Input Operating Voltage 10 to 30VDC
AC Power Supply Rating Input 110-240VAC, Output 15VDC - 2A
Width 8.90 in. (226 mm)
Height 5.67 in. (144 mm)
Depth 1.75 in. (44.5 mm)
Weight (including battery
pack)
2.1 lb (952 g)
Operating Temperature
Range (ambient)
At 0 to 90% relative humidity (non-condensing)
32 to 113°F (0 to 45°C)
Storage Temperature
(ambient)
At 0 to 70% relative humidity (non-condensing)
–4 to 140°F (–20 to 60°C)
Environmental Conditions
This product is intended for indoor use only
This product is rated for Pollution Degree 2 (normal
conditions)