Snapmaker Artisan - CNC Carving and Cutting

Maintenance
164-165
7.3 CNC Carving and Cutting
7.3.1 Secure the Nut
Why
The nut on the CNC carving and cutting platform may fall off after long-time use or under improper operation.
When this happens, you need to glue it back.
How
Before the operation, wear protective gloves to prevent contact with the toxic AB glue and
wear protective equipment to avoid inhaling volatile toxic gases.
2. Clear the sawdust on the nut with the brush;
3. Squeeze out the A glue and B glue in a 1:1 proportion;
Do NOT mistakenly screw the lid of the A glue on the B glue.
1. Prepare the cleaning tools: tweezers, a brush, the AB glue, and protective gloves (the latter three not provided);