2-3
Before You Start
1.3 Safety Information & Compliance
1.3.1 General Safety Information
- Follow the applicable local laws and regulations in the operation and application of this product.
- Follow the instructions of the guide to use and maintain this product for safety purposes.
- Do not expose this machine to rain or wet conditions.
- Always operate this machine indoors on a solid horizontal table or workbench.
- Minors are only allowed to use this product under adult supervision and assistance.
- Ensure that bystanders also read and understand all the safety notes of this product and keep bystanders
away while operating this product for safety purposes.
- Stay alert, watch what you are doing, and pay attention to the surrounding environment when operating this
product.
- Do not use this product while you are tired or under the influence of drugs, alcohol, or medication.
- Do not reach inside the product or touch the moving parts while the product is still in operation.
- Do not leave the product unattended while it is still powered on.
- Always unplug the power cable from the electrical outlet before performing maintenance or modifications.
In all EU member states and UK, operation of 5150-5250 MHz is restricted to indoor use only.
Turn off the machine immediately and stop using this product if any of the following occurs:
- You smell burning in this product at any point.
- You see any damage to the interior components of this product.
- The machine stops working unexpectedly.
- Unusual lights, sparks, or sounds come out of this product which has never occurred previously.
1.3.2 3D Printing Safety Information
- Do not touch the nozzle, the glass build plate
,
and the heated bed when the machine is printing, heating, or
just finished printing.
- Use the 3D Printing Module together with the Snapmaker Enclosure (hereafter Enclosure).
- Use this product in combination with air purifying devices or in a well-ventilated environment, for some
filaments and materials may release toxic odors or fumes when melted.
- Always check the safety data sheet of each specific filament and material for safety information before
use. You might need to take additional safety measures when using this product with third-party filaments or
materials.
1.3.3 Laser Safety Information
- The 10W Laser Module is a Class 4 laser product. When you use the laser module correctly and in
combination with the Enclosure as required, the overall laser classification of this product is Class 1.
- You should operate this product only if you have sufficient knowledge of (i) the physical properties of laser
radiation, (ii) Laser Hazard Classes and associated health implications, and (iii) safety measures.
- The 10W Laser Module must be used together with the Enclosure. Please follow this guide to assemble and
use the Enclosure. During laser processes, the Enclosure helps to prevent the risk of laser leakage by effectively
filtering laser radiation and pausing the ongoing job if the Enclosure door is opened.
To Next Page
Loading...
