4-5
Before You Start
5. If necessary, use pain relievers or seek medical help immediately.
Inhalation of Fumes and Granules
- Fumes, smoke, or granules that irritate your respiratory system might be generated during 3D printing
,
laser, or CNC processes. Therefore, we recommend using this product with air-purifying devices or in a well-
ventilated environment. Wear protective masks if necessary.
- In case of respiratory irritation and other similar symptoms, immediately expose the patient to fresh air and
arrange for medical attention in time.
Exposure to Irritants
Some soluble filaments might be irritating to the human body. Before exposing yourself to such filaments,
always check the safety data sheet (SDS) provided by their manufacturers and take safety precautions.
1.3.7 FCC Compliance
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or Modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20
cm between the radiator and your body.
1.3.8 ISEDC Compliance
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device.
Operation of 5150-5250 MHz is restricted to indoor use only.
The device complies with RF exposure guidelines, users can obtain Canadian information on RF exposure and
compliance. The minimum distance from the body to use the device is 20 cm.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
To Next Page
Loading...
