Manuel d'entretien et d'utilisation
user maintenance guide
Step 4
1
4
3
2
Legend
1 Support
2 Screw
3 Top of the wheel
4 Steering column
● Tighten the steering wheel (straight side up (3)) with the 3
screws (2) on the steering wheel support (1).
● Tighten the steering wheel support (1) on the steering
column (4).
● Once the steering system is assembled,
please check that the steering wheel is free to
make a quarter of a turn right and left.
► A bad assembly or a bad adjustment of
the steering system can lead to accidents.
Systematically check the tightening of the
system and its adjustment.
3.6 - Assembly of the seat
● See chapter “standard settings” for the
assemblies’ dimensions which correspond to the
standard setting recommended for your frame.
1
1
2
2
1
1
Legend
1 Fixing points
2 Seat supports
● Get the seat supports (2) closer, or wider, depending on
the seat size.
● Use the shims of the seat xing kit to get a good t.
Ground clearance
A
3
4
Legend
1 Seat
2 Frame tubes
● Adjust the bottom of the seat (1) with the lower face of the
frame tubes (2).
Seat Position
B
● Position the seat following dimension B.
● Drill a 8.5 mm diameter hole in the seat.
● Tighten up screws and washers on assembly points (1).
To Next Page
Loading...
