Sodi SIGMA - Replacing the Front Master Cylinder Pistons

MAN_Sigma_16_GB_00
33
MAN_Sigma_16_GB_00
03/2016
Manuel d'entretien et d'utilisation
user maintenance guide
1
4
2
3
Legend
1 Pressure pin
2 Dust cover
3 Pin
4 Piston lever
● Reinstall the piston lever assembly (4) in the master
cylinder.
● Reinstall the pin (3).
● Reinstall the dust cover (2) and pressure pins (1) on the
master cylinder.
● Always use new seals.
● Replace any defective parts, using only
original SODIKART parts.
6.2.4 - Replacing the front master cylinder pistons
This operation must be performed by a Sodikart
dealer.
PFG110
5
2
1
3
4
Legend
1 Screw
2 Nut
3 Handle
4 Push rod
5 Piston
Removing
● Remove the screw (1) and the nut (2).
● Remove the handle (3) and the push rod (4).
● Remove the piston (5) from the master cylinder.
● Clean the body of the master cylinder. Do not use WD40 or
other greasy products to clean the master cylinder.
► Do not use any cleaning product that could
damage the seals. A brake uid leak could
appear, causing a serious or fatal accident.
Reassembly
● Apply PFG110 grease to the piston (5).
● Reinsert the piston (5) in the master cylinder.
● Reinstall the handle (3) and push rod (4) using the screw
(1) and nut (2).
● Replace any defective parts, using only
original SODIKART parts.