Manuel d'entretien et d'utilisation
user maintenance guide
6 - Maintenance
6.1 - Brakes - Usual maintenance
6.1.1 - Fluids and lubricants
Do not use any oil-based lubricant, which would cause swelling of the rubber parts.
SODIKART recommends the use of DOT 4 brake uid (refer to the ITAKA web site for product references) and recommends
that the disc and pads should be cleaned using brake cleaner only (refer to the ITAKA web site for product references).
Use PFG110 grease to install the seals (visit the ITAKA site for product catalogue numbers).
Brake uid.....................“TYP200” ................Ref : LU842.010
► The “TYP200” brake uid has been designed for racing use and is used exclusively for
this purpose (forbidden on open road).
Brake cleaner ...............WYNN’S .................................. Ref : LU835.001
Grease ..........................Graisse PFG110 ...................... Ref : LU823.004
► Use brake uid DOT4 only. Using another brake uid could cause leaks and failure of
the brake system.
● The brake system is not compatible with DOT 5.
● Place the uids in watertight cans and recycle them according to the regulations in force.
6.1.2 - Frequency of cleaning and maintenance
Before
any
session
After 1
meeting or
100 km
After 3
meeting or
300 km
After 5
meeting or
500 km
As
soon as
required
Checking the brake uid level X
Replacing the brake uid X
Checking the brake pads for wear X
Replacing the brake pads X
Checking for leaks in the hose X
Checking the condition of the brake hose X
Checking the tightness of the brake hose screew X
Checking the tightness of the kart brake system X
Checking the condition of the brake disc X
Checking the brake disc for wear X
Replacing the brake disc X
To Next Page
Loading...
