35
MAN_Sigma_16_GB_00
03/2016
Manuel d'entretien et d'utilisation
user maintenance guide
6.3.2 - Table of the recommended tyre pressures
Pressure (bar)
Slick tyres Cold (20°) Warm
Categories Brand Type Front Rear Front Rear
KF2 –SLICK VEGA XM 0,5 0,5 0,7 0,7
KF3 –SLICK VEGA XH 0,6 0,6 0,8 0,8
KZ VEGA SL4 0,7 0,65 0,85 0,85
KZ2 VEGA XM 0,5 0,45 0,75 0,75
X30 KOMET K1H 0,65 0,7 0,85 0,9
ROTAX MAX MOJO F2 0,7 0,65 0,9 0,9
ROTAX MAX Euro challenge MOJO D2 0,7 0,65 0,9 0,9
ROTAX Junior MOJO D1 0,9 0,85 1,05 1,05
ROTAX DD2 MOJO D3 0,65 0,55 0,85 0,85
NATIONALE MOJO F1 0,9 0,85 1,05 1,05
Wet tyres Cold (20°) Warm
Categories Brand Type Front Rear Front Rear
KF2/KF3 VEGA W5 1 1 1,1 1,1
KZ VEGA W5 1 1 1,1 1,1
KZ2 VEGA W5 1 1 1,1 1,1
X30 KOMET K1W 1 1 1,1 1,1
ROTAX MAX MOJO W2 1,2 1,2 1,3 1,3
ROTAX DD2 MOJO W2 1,2 1,2 1,3 1,3
NATIONALE MOJO (slick) F1 2,5 2,5 2,5 2,5
Wet conditions:
● Little water: slightly drop the pressure from the
recommended value.
● Much water: increase the pressure from the recommended
value.
6.4 - Cleaning the chassis
The cleaning of the chassis and its components is to be done
with a special cleaning product (refer to the ITAKA web site).
Do not use the product on brake pads and brake calipers.
This uid cleans, removes grease, protects, lubricates and
protects the rotating parts from damp (stub axle, tie rods, etc).
● Protect the break calipers and the brake disk with a dry
piece of cloth.
● Spray the whole kart with the cleaning product, and let it
act for 30 seconds.
● Wipe the frame and the components with a dry cloth.
● Clean your kart on a regular basis: it is a good
way to check it and detect damages, if any.
● The complete kart cleaning must be done after
each run.
► Spray cleaning product on brake pads or
brake caliper may reduce the braking ability
partially or totally, and can lead to a serious
accident.
To Next Page
Loading...
