Sofar ME3000SP - Page 29

29
9. Set EPS (Emergency Power Supply) Mode
9. Set EPS Mode
1.EPS Mode Control
1.Enable EPS Mode
2.Disable EPS Mode
2.Set EPS Changeover Time ***S
10. DRMs0 Control (ONLY for Australian Market)
Select “10. DRMs0 Control”, press “OK”, “input password” is shown. Input the password “0001”, press “Up” or
“Down” to change the 1
st
digit, press “OK” to switch to next digit, when “0001” is shown on the screen, press
“OK”.
After entering DRMs0 control interface, press “up” or “down” to select “1. Enable DRMs0” or “2. Disable DRMs0”,
press “OK”.
11. Auto Test (ONLY for Italian Market)
Select “11. Auto Test”, press “OK” to enter autotest interface.
11.Auto Test
1.Autotest Fast
2.Autotest STD
3.QF Time Setting
4.QV Time Setting
5.Control 81.S1
1) Autotest Fast
Select “1. Autotest Fast”, then press “OK” to start Auto test Fast.
Start Autotest
↓
Press “Ok” to start
Testing 59.S1...
↓
Wait
Test 59.S1 OK!
↓
Wait
Testing 59.S2...
↓
Wait
Test 59.S2 OK!
↓
Wait
Testing 27.S1...
↓
Wait
Test 27.S1 OK!
↓
Wait
Testing 27.S2...
↓
Wait
Test 27.S2 OK!
“Up” ↑
“Down”↓