3 Hang the inverter on the bracket using the screws at the top of the inverter, as shown below. Let the
inverter lay flat against the wall or pole.
Figure 6: Hanging the inverter on the bracket
4 Insert the two supplied screws through the outer heat sink fin on both sides of the inverter and into
the bracket. Tighten the screws with a torque of 4.0 N*m / 2.9 lb*ft.
Figure 7: Inserting the screws into the outer heat sink fins
CAUTION:
HEAVY OBJECT. The single phase inverter weighs 20-21 kg and the three phase weighs 33 kg.
To avoid muscle strain or back injury, use proper lifting techniques, and if required - a lifting aid
when removing or replacing.
To Next Page
Loading...
