SolarEdge Solar Inverter - Server Communication Status; IP Status; Zigbee Status

Chapter 5: User Interface
SolarEdge Installation Guide – MAN-01-00057-2.2
38
Server Communication Status
S e r v e r : L A N < S _ O K >
S t a t u s : <OK>
x x x x x x x x
< E R R O R M E S S A G E >

Server: The method of connection to the SolarEdge monitoring portal

S_OK: The connection to the SolarEdge monitoring portal is successful (should appear only if the
inverter is connected to the server).

Status: Displays OK if the inverter established a successful connection and communication with the
specified server port/device (LAN, RS485 or ZigBee module).

xxxxxxxx: Eight-bit Ethernet communication connection status: A string of 1s and 0s is displayed.
1 indicates OK, 0 indicates an error. For a list of the possible errors and how to troubleshoot them,
refer to Troubleshooting Communication on page 50.

Error message, according to failure
Refer to Troubleshooting Communication on page 50 for detailed information.
IP Status
This window describes the Ethernet configuration: IP, Mask, Gateway and MAC address (Media Access
Control) of the inverter.
I P 1 9 2 . 1 6 8 . 2 . 1 1 9
M S K 2 5 5 . 2 5 5 . 2 5 5 . 0
G W 1 9 2 . 1 6 8 . 2 . 1
M A C 0 - 27- 02- 00- 39- 36
ZigBee Status
This window describes the ZigBee configuration:
PAN: X X X X X
C h : X X / X X X X R S S I : < L >
ID:X X X X X X X X
M I D : X X X X X X

RSSI: The receive signal strength indication of the closest ZigBee in the SolarEdge system. L = low,
M = medium, H = high and (-) = no signal.

PAN ID: The ZigBee transceiver pan ID

Ch.: The ZigBee transceiver channel

ID: The ZigBee transceiver ID

MID: The Master ID of the coordinator (master) ZigBee module. This field is shown only in devices
with router (slave) ZigBee modules. This field appears after a successful ZigBee association. If a
ZigBee module is not connected, a No ZigBee message is displayed instead of the MID field.