Power Control
For detailed information about active and reactive power control options refer to the Power Control
Application Note, available on the SolarEdge website at
http://www.solaredge.com/files/pdfs/application_note_power_control_configuration.pdf.
G r i d C o n t r o l < D i s >
R R C R C o n f .
P h a s e B a l a n c e < E N >
L o a d D e f a u l t s
The Grid Control option is disabled by default. Enabling it opens additional options in the menu, as shown
on page 31.
Display
Select Display to set the following three options:
T e m p e r a t u r e < F >
L C D O n T i m e < 3 0 >
T L M O n T i m e < 1 5 >
Temperature: Select Celsius or Fahrenheit units.
LCD On Time <30>: The number of seconds that the LCD backlight is ON after pressing the LCD light
button. Set a value within the range of 10-120 seconds.
TLM On Time <15>: The number of minutes that the LCD backlight is ON while viewing the Telemetry
window. Set a value within the range of 1-120 minutes.
Maintenance
Select Maintenance to set the following options:
D a t e a n d T i m e
R e s e t C o u n t e r s
F a c t o r y R e s e t
S W U p g r a d e - S D C a r d
Date and Time: Set the internal real-time clock. If connected to the SolarEdge monitoring portal, the
date and time are set automatically and only time zone should be set.
Reset Counters: Reset the accumulated energy counters that are sent to the SolarEdge monitoring
portal
Factory Reset: Perform a general reset to the inverter default settings.
SW Upgrade SD Card: Perform a software upgrade using an SD card.
NOTE:
Phase Balance is applicable to single phase inverters only. For detailed information, refer to the
SolarEdge Phase Balancing Manual, available on the SolarEdge website at
http://www.solaredge.com/files/pdfs/phase_balancing_connection_guide.pdf
To Next Page
Loading...
