Solartron 1287 - Avoid Unsafe Equipment; Live Conductors; Equipment Modification

SAFETY
PRECAUTIONS
(continued from previous
page)
SAFETY
SYMBOLS
For the guidance
and protection
of
the user, the following
safety symbols
appear
on the equipment:
SYMBOL
MEANING
Refer
to operating
manual for detailed instructions
of use.
Hazardous
voltages.
Protective
conductor
terminal. This
must be connected to
ground before
operating the
equipment.
AVOID UNSAFE
EQUIPMENT
The equipment may
be unsafe
if
any
of the following
statements apply:
•
Equipment shows
visible damage.
•
Equipment
has failed to
perform
an intended operation.
•
Equipment
has been subjected
to prolonged
storage under unfavorable
conditions.
•
Equipment
has been subjected
to severe physical
stress.
If
in any doubt as
to the serviceability
of the equipment,
don’t use it.
Get it
properly checked
out by a qualified
service technician.
LIVE
CONDUCTORS
When
the equipment
is connected
to its
measurement inputs or
supply, the
opening of covers
or removal
of parts
could expose
live conductors. The
equipment
must be
disconnected from
all power
and signal sources before
it is
opened for
any adjustment,
replacement,
maintenance or repair.
Adjustments,
maintenance
or repair,
must be done
only by qualified
personnel, who
should
refer to the Servicing
Manual.
EQUIPMENT
MODIFICATION
To avoid
introducing safety
hazards, never
install non-standard
parts in the
equipment,
or make
any unauthorized
modification.
To maintain safety,
always
return the equipment
to Solartron
for service
and repair.