10
3 Storage
This chapter describes the storage requirements for the inverter.
The following storage instructions apply if the PV inverter will not be deployed immediately:
> .Do not unpack the inverter (put desiccant in the original box if the PV inverter is unpacked)
> ℃ ℃Store the PV inverter at a temperature range of -40 to +70 and with the relative humidity
of 0% to 100% (no condensing).
The PV inverter should be stored in a clean and dry place and be protected from dust and>
water vapor corrosion.
A maximum of four layers of inverters can be stacked.>
> , , , .Do not position the inverter at a front tilt excessive back tilt or side tilt or upside down
> .Conduct periodic inspection during storage Replace the packing materials immediately if any
rodent bites are found.
Ensure that qualified personnel inspect and test the inverter before use if it has been stored>
for a long time.
To Next Page
Loading...
Need help?
General
