Logic Pro 8
When Logic is assigned to one of the two Duality workstation layers a Mackie Control together with a Mackie Control
Extender must be added to the Logic Pro Preferences/Control Surfaces Setup menu as shown below:
Duality Faders 1-8 are mapped to the Mackie Control ports along with the Master Fader and workstation Control function
switches. Duality Faders 9 -16 and 17-24 are mapped to the Mackie Control Extender ports. The actual ipMIDI ports used
will depend on which layer (or layers) Logic is assigned to. See the list of Duality MIDI port assignments for details. It is
essential that the layout shown is followed. If the physical arrangement is reversed, then the Duality faders will not map
correctly to the on-screen faders in Logic.
If the protocol is set to Logic Handshake, Logic should automatically detect six virtual controllers which will be shown
in the Logic Setup menu (as shown above), with the appropriate Duality ipMIDI ports assigned. If Logic fails to detect the
control surfaces, then the controllers can be added manually via the New/Install menu and the appropriate MIDI Out port
and Input assigned. As described above, normally only one layer should be set to Logic Handshake, otherwise Logic
will detect and connect to all 12 MIDI ports!
Full details can be found in the online Logic Pro 8 Control Surfaces Support guide in the Logic Help Menu.
Page 31
Duality SE Installation Guide
Section 4 System Installation
To Next Page
Loading...
Need help?
General
