1.2 Packaging
When you receive the inverter, ensure that all the parts listed below are included:
Manual
Inverter x1
Mounting bracket x1
Expansion screws x3
Locking screws x2
Manual x1
1.3 Storage
● Use the original box to repackage the inverter, seal with adhesive tape with the desiccant inside
the box.
● Store the inverter in a clean and dry place, free of dust and dirt. The storage temperature must be
between 40~176°F and humidity should be between 0 to 95%, non-condensing.
● Do not stack more than four (4) inverters high on a single pallet.
● Keep the box(es) away from corrosive materials to avoid damage to the inverter enclosure.
● Inspect the packaging regularly. If packing is damaged (wet, pest damages, etc.), repackage the
inverter immediately.
● Store inverters on a flat, hard surface -- not inclined or upside down.
● After 100 days of storage, the inverter and carton must be inspected for physical damage before
installing. If stored for more than 1 year, the inverter needs to be fully examined and tested by
qualified service or electrical personnel before using.
● Restarting after a long period of non-use requires the equipment be inspected and, in some cases,
the removal of oxidation and dust that has settled inside the equipment will be required.
If the inverter is not installed immediately, storage instructions and environmental conditions are below:
1. Introduction
User Manual
4
To Next Page
Loading...
