6.5.7.9 IgZero_COMP.Set
6.5.7.10 PI Set
This function is for maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
This function is for maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
6.5.7.11 IgADCheckPRO Set
This function is for maintenance personnel only, wrong operation
will prevent the inverter from reaching maximum power.
6.5.8 STD. Mode Settings
1. Working Mode Set
2.Power Rate Limit
3.Freq Derate Set
4.10mins Voltage Set
5.Power Priority
6.Initial Settings
7.Voltage PCC Set
8.Freq-Watt
Selecting “STD Mode. Settings” displays the sub-menu shown below:
6.5.8.1 Working Mode Set
6.5.8.1.1 With UL Standard selected
There are TWO situations with different grid standards selected.
6. Operation
User Manual
35
NOTE:
The following modes are for "UL-240-18".
To Next Page
