Sonel MPI-520 - 2.4 Language selection; 2.5 Information about manufacturer

MPI-520 OPERATING MANUAL version 3.4
11
2.3.5 Factory (default) settings
In order to introduce factory (default) settings, highlight YES by means of , push-buttons and
press ENTER push-button.
2.3.6 Program update
ATTENTION!
This function may be used only by the users who are fluent in operation of computer
equipment.
The guarantee does not cover defective operation of the device resulting from wrong
use of this function.
ATTENTION!
A new package of batteries should be installed before programming or the accumula-
tor should be charged.
During programming the meter must not be switched off as well as the transmission
cable must not be disconnected.
Before updating the program, download the program that is use for programming the meter from
the manufacturer’s website (www.sonel.pl), install this program on your computer and connect the
meter to the computer.
Select Software upgrade in the MENU and follow the instructions displayed by the program.
2.4 Language selection
 By means of and push-buttons choose **Language choice** in the main MENU; press
ENTER push-button.
 Select a required language by means of and push-buttons; press ENTER push-button.
2.5 Information about manufacturer
By means of and push-buttons choose Manufacturer info in the main MENU; press
ENTER push-button.