Sonel MPI-520 - Deleting Memory Data

MPI-520 OPERATING MANUAL version 3.4
46
No.
Main result
Supplementary results
21
CABLE 5: R
ISO
(N-PE),
R
ISO
(L1-PE),
R
ISO
(L1-N),
U
ISO
, [LIMIT I], [NOISE]
U
ISO
, [LIMIT I], [NOISE]
U
ISO
, [LIMIT I], [NOISE]
22
CABLE 5: R
ISO
(L2-N),
R
ISO
(L3-N),
R
ISO
(L1-L2),
U
ISO
, [LIMIT I], [NOISE]
U
ISO
, [LIMIT I], [NOISE]
U
ISO
, [LIMIT I], [NOISE]
23
CABLE 5: R
ISO
(L1-L3),
R
ISO
(L2-L3),
R
ISO
(L2-PE),
U
ISO
, [LIMIT I], [NOISE]
U
ISO
, [LIMIT I], [NOISE]
U
ISO
, [LIMIT I], [NOISE]
24
CABLE 5: R
ISO
(L3-PE),
U
ISO
, [LIMIT I], [NOISE]
25
R 200 mA
R
F
R
R
[NOISE !]
Remarks:
- While viewing the memory, empty measurements and memory banks are not accessible. “Meas-
urement 1/20” signifies the first of the 20 measurements; measurements 21…99 are empty and inac-
cessible. The same principle applies to memory banks. If the memory is stored in a non-continuous
manner, empty measurements and memory banks are omitted while the memory is being viewed.
4.3 Deleting memory data
Set the rotary switch of function selec-
tion at MEM position.
Select “Memory erasing” by means of
and push-buttons.