Sonel MPI-520 - Page 51

MPI-520 OPERATING MANUAL version 3.4
49
5. Set the required code with the cursors.
The same code must be entered in the computer programme. It is used for securing transmission.
6. To start transmission, select Wireless transmission in the MENU or press F1 in the MEM posi-
tion. The following messages will be displayed: Connecting and then Connection active. If it is im-
possible to establish connection the message Wireless connection lost will appear. Once the con-
nection is established, follow the programme manual for data filing.
Note:
Standard pin for OR-1 is the „123”. Settings in the meter according to section 2.2.