65
Display Function Menu
Chapter 3 Menu
Capture
Rename Changes a file name of the captured picture in the “Memory Stick”.
When the item is selected, the file names are displayed.
When the file name is selected, you can change the file name (1 to 20 characters).
Existing file name: Enter the existing file name.
New Name: Enter a new file name.
Note
The “.” must not be used as the first character.
Delete Deletes the file of the captured picture in the “Memory Stick”.
When the item is selected, the file names in the “Memory Stick” are displayed.
When the file name is selected, the following message appears.
Delete this file?
OK: To delete the data, press the ENTER (Ent) button.
Cancel: To cancel, press the MENU button.
Internal Signal Selects the internal signal display.
You can select from PLUGE, Gray (20% gray signal), White (100% white signal), 5 step (5
step gray scale signal), Ramp, Color Bars or Black (0% black signal).
To cancel the internal signal, select one from the channel numbers 1 to 30 with the numeric
buttons of the controller.
Note
Internal Signal is not set in the following cases:
• When the XYZ or DVI Computer format signal is input
• When Side by Side is set to On
• When Wipe is set to On
• When Butterfly is set to On
• When Blending is set to On
Function Switch Sets the function to be assigned to the function button of the controller in the menu.
Scan Mode Sets the scan size of the picture.
[Normal Scan]: Normal scan
Under Scan: 3% under scan
Over Scan: Mask of 5% over scan portion in the normal scan
Note
The scan size is not selectable in the following cases:
• When Native Scan is set to On
• When the input signal has no sync signal
• When the internal signal is displayed
• When Side by Side is set to On
• When Wipe is set to On
• When Butterfly is set to On
• When Blending is set to On
Native Scan Sets whether or not to display the native scan ([Off] or On).
Note
The native scan is not selectable in the following cases:
• When the input signal has no sync signal
• When Side by Side is set to On
• When Pixel Zoom is set to on
• When Format of the Input Configuration menu is set to DVI Computer (The native scan is
displayed regardless of the setting.)
• When a digital cinema signal (2048 × 1080) is input and the internal signal is displayed
(Native Scan is set to Off and the normal scan is displayed regardless of the setting.)
• When the signal system is the SD signal of 720 × 576 or 1440 × 576, Native Scan Mode is
set to Aspect Correction and the internal signal of the aspect ratio 16:9 is displayed (Native
Scan is set to Off and the normal scan is displayed regardless of the setting.)
16:9 Sets whether or not to display the aspect in 16:9 or 1.896:1 (digital cinema signal) (Off or
[On]).
Notes
• The aspect ratio is not selectable in the following cases:
- When Native Scan Mode is set to ×1 or ×2 and Native Scan is set to On
- When the input signal has no sync signal
• The aspect ratio may be fixed due to the signal format.
For details, see “Available Signal Formats” on page 102.
Menu Function and operation ([ ]: factory setting)
To Next Page
Loading...
