67
Display Function Menu
Chapter 3 Menu
Function Switch
G Off Sets whether or not to cut the green signal ([Off] or On).
Note
When the displayed signal is XYZ, the green signal is not cut.
B Off Sets whether or not to cut the blue signal ([Off] or On).
Note
When the displayed signal is XYZ, the blue signal is not cut.
Chroma Up Sets whether or not to increase the chroma value by 12 dB ([Off] or On).
Note
The chroma value is not increased in the following cases:
• When the signal to be displayed is RGB or XYZ
• When the composite signal is automatically displayed in monochrome depending on the
color discrimination of the input adaptor
• When the internal signal is displayed
Black Frame Insertion Sets whether or not to display in black frame insertion mode ([Off] or On).
Note
The black frame is not inserted in the following cases:
• When Interlace is set to On
• When the 24P or 24PsF input signal is displayed
• When Format of the Input Configuration menu is set to DVI Computer
For details of this menu, see “Selecting Display Mode” on page 84.
Interlace Sets whether or not to display in interlace mode ([Off] or On).
Notes
• Set Native Scan to On for the interlace display.
• The picture is not displayed in interlace mode in the following cases:
– When Side by Side is set to On
– When Wipe is set to On
– When Butterfly is set to On
– When Blending is set to On
– When Pixel Zoom is set to on
For details of this menu, see “Selecting Display Mode” on page 84.
Marker Sets whether or not to display all markers ([Off] or On).
Note
The marker is not displayed in the following cases:
• When the input signal has no sync signal
• When the internal signal is displayed
• When Format of the Input Configuration menu is set to DVI Computer
• When H Delay/V Delay is set to On
• When Side by Side is set to On
• When Wipe is set to On
• When Butterfly is set to On
• When Blending is set to On
• When Pixel Zoom is set to on
Aspect Marker Sets whether or not to display the aspect marker ([Off] or On).
Note
The aspect marker is not displayed in the following cases:
• When the input signal has no sync signal
• When the internal signal is displayed
• When Format of the Input Configuration menu is set to DVI Computer
• When H Delay/V Delay is set to On
• When Side by Side is set to On
• When Wipe is set to On
• When Butterfly is set to On
• When Blending is set to On
• When Pixel Zoom is set to on
Menu Function and operation ([ ]: factory setting)
To Next Page
Loading...
