68
Display Function Menu
Chapter 3 Menu
Function Switch
Area Marker 1 Sets whether or not to display the area marker 1 ([Off] or On).
Note
The area marker 1 is not displayed in the following cases:
• When the input signal has no sync signal
• When the internal signal is displayed
• When Format of the Input Configuration menu is set to DVI Computer
• When H Delay/V Delay is set to On
• When Side by Side is set to On
• When Wipe is set to On
• When Butterfly is set to On
• When Blending is set to On
• When Pixel Zoom is set to on
Area Marker 2 Sets whether or not to display the area marker 2 ([Off] or On).
Note
The area marker 2 is not displayed in the following cases:
• When the input signal has no sync signal
• When the internal signal is displayed
• When Format of the Input Configuration menu is set to DVI Computer
• When H Delay/V Delay is set to On
• When Side by Side is set to On
• When Wipe is set to On
• When Butterfly is set to On
• When Blending is set to On
• When Pixel Zoom is set to on
Side by Side Sets whether or not to display in the side by side display ([Off] or On).
Note
The side by side display is not set in the following cases:
• When the internal signal is displayed
• When Pixel Zoom is set to on
Wipe Sets whether or not to display in the wipe display ([Off] or On).
Note
The wipe display is not set in the following cases:
• When the internal signal is displayed
• When Pixel Zoom is set to on
Butterfly Sets whether or not to display in the butterfly display ([Off] or On).
Note
The butterfly display is not set in the following cases:
• When the internal signal is displayed
• When Pixel Zoom is set to on
Blending Sets whether or not to display in the blending display ([Off] or On).
Note
The blending display is not set in the following cases:
• When the internal signal is displayed
• When Pixel Zoom is set to on
Error Notify Clear When the item is selected, the notification of the gamut error detection is cleared.
Black Detail Mode Sets whether or not to display the signal in black detail mode ([Off] or On).
Note
The black detail mode is not set in the following cases:
• When Interlace is set to On
• When Black Frame Insertion is set to On
• When H Delay/V Delay is set to On
Menu Function and operation ([ ]: factory setting)
To Next Page
Loading...
