25
GB
Getting Started
5 Connecting the Antenna (Aerial)
Note
• Keep the AM loop antenna (aerial) and cord away from the system or other AV components, as noise may result.
• Be sure to fully extend the FM wire antenna (aerial).
• After connecting the FM wire antenna (aerial), keep it as horizontal as possible.
Ti
• Adjust the direction of the AM loop antenna (aerial) for best AM broadcast sound.
• If you have poor FM reception, use a 75-ohm coaxial cable (not supplied) to connect the control unit to an outdoor
FM antenna (aerial) as shown below.
DMPORT
A
B
Rear of the control unit
AM loop antenna (aerial) (supplied)
FM wire antenna (aerial)
(supplied)
Note
• Cord (A) or cord (B) can be connected to
either terminal.
AM
FM 75
COAXIAL
ANTENNA
Control unit
Outdoor FM
antenna (aerial)
To Next Page
Loading...
