Control for HDMI/External Audio Device
67
GB
The unit is compatible with the S-AIR function
(page 106), which allows sound transmission
between S-AIR products.
When you purchase the S-AIR product, you
need to perform the following settings to
establish the sound transmission.
About S-AIR products
There are two types of S-AIR product.
• S-AIR main unit (control unit and subwoofer
in this system): This is for transmitting sound.
You can use up to 3 S-AIR main unit. (The
number of usable S-AIR main unit depends on
the use environment.)
• S-AIR sub unit (not supplied): This is for
receiving sound.
– Surround amplifier: You can enjoy
surround speaker sound wirelessly.
– S-AIR receiver: You can enjoy system
sound in another room.
Inserting the wireless
transmitter/transceiver
To make use of the S-AIR function, you need to
insert the wireless transmitter (not supplied) into
the S-AIR main unit and the wireless transceiver
(not supplied) into the S-AIR sub unit.
Note
• When you insert the wireless transmitter/transceiver,
make sure that the AC power cord (mains lead) is not
connected to a wall outlet (mains).
• Do not touch the terminals of the wireless transmitter/
transceiver.
To insert the wireless transmitter
into the S-AIR main unit
1 Remove the screws and detach the slot
cover.
Note
• Remove the screws from the slot cover bearing
the caution mark. Do not remove other screws.
• The slot cover is no longer necessary; however,
keep it after detaching.
2 Insert the wireless transmitter.
Using an S-AIR Product
S-AIR sub unit
(surround amplifier, not supplied)
S-AIR main unit (control unit
and subwoofer)
S-AIR sub unit
(S-AIR receiver,
not supplied)
Rear of the subwoofer
Slot cover
Rear of the subwoofer
cont
nue
To Next Page
Loading...
