Sony DAV-IS50 - Page 85

Advanced Settings and Adjustments
85
GB
Note
• Depending on the DVD, [4:3 LETTER BOX] may be
selected automatically instead of [4:3 PAN SCAN] or
vice versa.
x [PROGRESSIVE (COMPONENT OUT)]
You can set the progressive signal that is output
from the COMPONENT VIDEO OUT jacks to
on/off. For details, see “Does your TV accept
progressive signals?” (page 30).
1 Select [ON], then press .
The confirmation display appears.
2 Press C/c to select [START].
The system outputs the progressive signal
for 5 seconds. Check that the screen is
displayed correctly.
3 Press C/c to select [YES].
The system outputs the progressive signal.
If you select [NO], the system will not
output the progressive signal.
Note
• [PROGRESSIVE (COMPONENT OUT)] is
effective only when you connect the control unit and
TV with a component video cord (page 21).
x [4:3 OUTPUT]
When you use a 16:9 aspect ratio TV, you can
adjust the aspect ratio to watch 4:3 aspect ratio
signals. If you can change the aspect ratio on
your TV, change the setting on your TV, not the
system.
Note
• [4:3 OUTPUT] is effective only when you set [TV
TYPE] in [VIDEO SETUP] to [16:9].
x [COLOR SYSTEM (VIDEO CD)]
(Asian, Oceanian and Middle Eastern
models only)
You can select the color system when you play a
VIDEO CD.
Note
• You cannot change the color system of the disc itself.
• You can change the color system of this system
according to the connected TV (page 21).
x [BLACK LEVEL]
(Latin American models only)
You can select the black level (setup level) for
the video signals output from the jacks other
than COMPONENT VIDEO OUT/HDMI OUT.
[ON]
The system outputs interlace
signals.
[OFF]
The system outputs progressive
signals. When you select [ON],
follow the steps below.
[FULL]
Select this when you can change
the aspect ratio on your TV.
[NORMAL]
Select this when you cannot
change the aspect ratio on your
TV. A 16:9 aspect ratio signal
with black bands on left and right
sides of the image appears.
[AUTO]
The system outputs the video
signal in the disc, either PAL or
NTSC. If your TV uses a DUAL
system, select [AUTO].
[PAL]
The system changes the video
signal of an NTSC disc and
outputs it in the PAL system.
[NTSC]
The system changes the video
signal of a PAL disc and outputs it
in the NTSC system.
[ON]
The standard level.
[OFF]
You can lower the standard black
level. Use this when the picture
becomes too white.
16:9 aspect ratio TV
cont
i
nue
d