Dubbing only desired scenes - Digital program editing
You can adjust the synchronization of your camcorder and tile VCR.
Remove tile cassette fl'om tile camcorder beforehand. We recommend that you prepare
a pen and paper for notes.
When you connect to a Sony VCR using an i.LINK cable (DV connecting cable), and
have set CONTROL to i.LINK, the setup below is not necessary.
(1) Insert a recordable tape into the VCR, then set it to recording pause.
When you connect using an i.LINK cable (DV connecting cable) and have set
CONTROL to i.LINK, you do not have to turn the recording VCR to recording
pause mode.
(2) Set tile POWER switch to VCR.
(3) Press MENU to display tile menu.
(4)Turn tile SEL/PUSH EXEC dial to select _, then press tile dial.
(5)Turn the SEL/PUSH EXEC dial to select EDIT SET, then press the dial.
(6)Turn tile SEL/PUSH EXEC dial to select ADJ TEST, then press tile dial.
(7)Turn tile SEL/PUSH EXEC dial to select EXECUTE, then press tile dial.
CUT-IN and CUT-OUT are recorded on an image for five times each to calculate
the nunlerical values for adjusting the synchronization.
The EXECUTING indicator flashes on the LCD screen or in tile viewfinder. When
finished, tile indicator changes to COMPLETE.
(8) Rewind the tape in the VCR, then start slow playback.
Take a note of the opening numerical value of each CUT-IN and the closing
numerical value of each CUT-OUT.
(9) Calculate the average of all the opening numerical values of each CUT-IN, and the
average of all the closing numerical values of each CUT OUT.
3 MENU
81
To Next Page
Loading...
