Sony DCR-VX2000 - Page 96

Audio dubbing
Notes
• New sound cannot be recorded on a tape already recorded in tile 16-bit mode (p. 111).
• New sound cannot be recorded on a tape already recorded in the LP mode.
• You cannot add audio with the g DV IN/OUT jack.
If you make all the connections
Tile audio input to be recorded will take precedence over others in tile fbllowing order.
• MIC (PLUG IN POWER) jack
• Intelligent accessory shoe
• AUDIO L/R jacks
• Built-in microphone
If an i.LINK cable (DV connecting cable) (not supplied) is connected to your
camcorder
You cannot add sound to a recorded tape.
If you set the write-protect tab of the tape to lock
You cannot record on tile tape. Slide tile write-protect tab to release tile write protection.
We recommend that you add new sound on a tape recorded with your camcorder
If you add new sound on a tape recorded with another camcorder (including an other
DCR-VX2000), the sound quality may deteriorate.
To add new sound more precisely
Press ZERO SET MEMORY on tile Remote Commander at tile point where you want to
stop recording later in playback mode. Then, follow tile procedure from step 3.
Recording automatically stops at the point where ZERO SET MEMORY was pressed.
On blank portions
You cannot add an audio.
You can adjust the recording level manually using the recording adjustment
display in the following cases:
Dubbing with an optional external microl)hone or audio equipment through tile MIC
jack
Dubbing with an optional external microphone installed into the intelligent accessory
shoe.
Dubbing with the internal microphone
96