Sony DSC-F828 - Color Shade Check

6-17
DSC-F828
7) When the “Completion of adjustment” message is displayed.
Click the [OK] button.
Fig. 6-1-30
5. Color Shade Check
Compensate the color shade.
Mode STILL (P AUTO) ( P )
Subject Clear chart (PTB-1450)
(Standard picture frame)
About 6cm from the front of the lens
Adjustment Page 6F
Adjustment Address 06, 07
Note 1: Check that there are no reflections on the clear chart.
Switch setting:
Mode dial ............................................STILL (P AUTO) ( P )
ZOOM .................... WIDE end (Turn the zoom ring to “28”)
MACRO ............................................................................. ON
FOCUS................................................................... MANUAL
Adjusting method:
1) Start the DSC-F828 C1 MATRIX ADJ on the PC.
2) Click
[Connect] on the DSC-F828 C1 MATRIX Adjustment
screen. If the connection is normal, the DSC-F828 C1 MA-
TRIX Adjustment screen will be as shown in bellow, indicat-
ing the “connected” state
3) Set up the switches of camera as above-mentioned.
4) Check that the picture frame is the standard picture frame.
5) Click [Color Shading Adjustment] on the DSC-F828 C1 MA-
TRIX Adjustment screen.
Fig. 6-1-28
6) Color shading adjustment is performed automatically.
Fig. 6-1-29