Sony DSC-F828 - Data Save Error; Precautions When an Error Occurred

6-29
DSC-F828
5. Data Save Error
Fig. 6-1-73
Symptom data cannot be saved normally. (The data set-
ting during adjustment cannot be cancelled)
Cause • Data writing to the flash memory failed.
• Connection is faulty.
• Power supply is not installed correctly.
Remedy • On the SEUS Operation screen, [Set] the data
to the pages and addresses displayed in the
message, and [Save] them. (Cancel manu-
ally the data setting during adjustment.)
• Check the connection.
• Install the power supply correctly.
1-7-2. Precautions When an Error Occurred
The Automatic Adjustment Program sets the data for adjustment
before the adjustment starts. Accordingly, if the adjustment termi-
nates by an error, the data during the adjustment may be left in the
camera.
Note 1: With this data left in the camera, the camera will not
operate normally.
In this case, the [Release Data Setting] button is displayed in
“red” on the screen as shown in Fig. 6-1-74 to Fig. 6-1-77. Click
the [Release Data Setting] button to cancel the data setting. When
the data setting is cancelled, the button color becomes “white”.
Note 2: When “Data Save Error” occurred, the [Release Data
Setting] button is displayed in “white”.
To cancel the data setting, perform it on the SEUS Op-
eration screen. How to cancel the data setting is displayed
in the error message.
Video System Adjustment screen
Fig. 6-1-74
Camera System Adjustment screen
Fig. 6-1-75
EVF System Adjustment screen
Fig. 6-1-76
LCD System Adjustment screen
Fig. 6-1-77
How to cancel the
data setting during
adjustment is
display here.