Sony DXC-D30P - Adjustment Item; Before Adjustment; Color Bar Signal Confirmation; Sensitivity Measurement Confirmation

DXC-D30 (UC)
DXC-D30P (CE)
3-3
3-1-5. Adjustment Item
3-2. Before Adjustment
3-2-1. Color Bar Signal Confirmation
3-2-2. Sensitivity Measurement Confirmation
3-3. Camera Adjustment
3-3-1. Sub-Carrier Frequency Adjustment
3-3-2. INT SC-H Phase Adjustment
3-3-3. Y/R-Y/B-Y CLP Level Adjustment
3-3-4. Y/SYNC/R-Y/B-Y Level Adjustment
3-3-5. Carrier Balance Adjustment
3-3-6. Chroma (VBS) Level Adjustment
3-3-7. Y (VBS) Level Adjustment
3-3-8. Y (YC) Level Adjustment
3-3-9. Chroma (YC) Level Adjustment
3-3-10. VF SYNC/BLKG Level Adjustment
3-3-11. CCD Output Level Adjustment
3-3-12. Pedestal Adjustment
3-3-13. Shading Adjustment
3-3-14. Flare Adjustment
3-3-15. MIC LEVEL/MIC Level IND Adjustment
3-3-16. Character Position Adjustment
(4) When replacing the CCD unit, be sure to perform the
following adjustment items.
3-3-12. Pedestal Adjustment
3-3-13. Shading Adjustment
3-3-14. Flare Adjustment
(5) If the amplitude level of the measured waveform is
blurred on the waveform monitor screen, set the
RESPONSE switch on the waveform monitor to “LUM”
mode.