20
4 Set the ON/STANDBY switch to
STANDBY (1).
The CHG lamp lights up and charging
starts.
When charging ends
The CHG lamp turns off when the battery is
fully charged.
Disconnect the AC Adaptor from the DC
IN jack.
z Tip
• You can check the remaining battery life with
the status check function (p. 59).
To remove the battery pack
Set the ON/STANDBY switch to
STANDBY (1). Press and hold the BATT
RELEASE button, and slide the battery up
and out.
To store the battery pack
If the battery pack is not in use for a while,
run down the battery and store it (p. 134).
Charging time
Approximate time (minutes) required when
you charge a fully discharged battery pack.
On the battery pack
• Always set the ON/STANDBY switch to
STANDBY (1) before changing the battery
pack.
• The CHG lamp flashes during charging, or the
Battery Info will not be correctly displayed
under the following conditions.
– The battery pack is not attached correctly.
– The battery pack is damaged.
– The battery pack is worn-out.
Using a power outlet
You can use the AC Adaptor to obtain the
AC power. While you are using the AC
Adaptor, the battery pack will not lose its
charge even when it is attached to your
camcorder.
Battery pack
Full charge
time
NP-F770 370
NP-F970 (sold separately) 485
BATT RELEASE button
Step 2: Charging the battery pack (Continued)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
