Operating instructions
Connecting a TV, VCR, and Satellite Receiver
4 From
1 _ _ cable/
antenna
2
VCR
@@@
Satellite receiver
1
31
_Rear of TV
1 Connect the coaxial cable from your satellite antenna to SATELLITE IN on the satellite
receiver.
2 Connect the coaxial cable from your cable service or antenna to the IN jack on your VCR.
3 Using a coaxial cable (not supplied), connect the OUT jack on your VCR to the VHF/UHF
jack on your TV.
4 Using audio/video cables (not supplied), connect AUDIO/VIDEO OUT on your satellite
receiver to AUDIO/VIDEO IN on your VCR.
5 Using audio/video cables (not supplied), connect AUDIO/VIDEO OUT on your VCR to
AUDIO/VIDEO IN on your TV.
UsingyourTVwith this connection
This connection allows you to do the following:
O Program your Sony remote control to operate your VCR or satellite receiver (see pages 7-8).
O Turn on your VCR to enable your satellite receiver to work with this connection.
_T_ .
O To activate your remote, press C_ to operate your VCR or C_ to operate your satellite
receiver.
O Press _ repeatedly to switch between VCR input (VIDEO input), VHF/UHF
(local channels or unscrambled), or your cable box (cable system or scrambled channels).
18
To Next Page
Loading...
