Sony MDS-E55 - Page 7

Basic Operations
When “TOC” flashes in the display
The deck is currently updating the
Table Of Contents (TOC).
Do not turn off MAIN POWER,
move the deck, or pull out the AC
power cord, while “TOC” is
flashing. Changes to an MD made
through recording are saved only
when you update the TOC by
ejecting the MD or changing the
deck to standby by pressing
POWER.
6 Press @ REC.
The deck becomes ready to record.
7 When recording the analog input signal, adjust the recording
level with REC LEVEL.
The fourth dot is satisfactory for most purposes. For details,
refer to “Adjusting the Recording Level” on page 11.
8 Press [= or §8.
Recording starts.
9 Start playing the program source.
Do not turn off MAIN POWER or disconnect the deck from the power source
immediately after recording.
If you do, recorded material may not be saved to the MD. To save the
material, after recording, press & EJECT to take out the MD or change the
deck to standby by pressing POWER. “TOC” will flash in the display at this
time.
After “TOC” stops flashing and is unlit, you can turn off MAIN POWER or
pull out the AC power cord.
To Press
Stop recording |
Pause recording* Il. Press the button again or press [> to
resume recording.
Take out the MD & EJECT after stopping recording
* Whenever you pause recording, the track number increases by one. For example, if
you paused recording while recording on track 4, the track number increases by
one and recording continues on the new track when restarted.
To protect an MD against accidental erasure
To make it impossible to record on an MD, slide the tab in the direction of
arrow, opening the slot. To allow recording, close the slot.
Rear of the disc
Record-protect tab
Slide the tab in
the direction of arrow
Note
If you switch REC MODE during recording or recording pause, recording stops.
FEN