Sony MVS-6530 - Destination

USO RESTRITO
152
Status Menu / Router Control Menu Operations
Chapter
8
Color
Backgrounds,
Copy
and
Swap,
and
Other
Settings
To set video processes: Turn on [Video Process] in
the <Video Process> group.
To set primary color correction: Turn on [Primary
CCR] in the <Primary CCR> group, and select the
item to set in the <Primary CCR Adjust> group.
To set an RGB clip: Turn on [RGB Clip] in the <RGB
Clip> group, and select the item to set in the <RGB
Clip Adjust> group.
4 Set the parameters.
For details about the parameters, 1 “Configuring
the Color Corrector” (p. 347).
To disable color correction
In the <CCR> group, press [CCR], turning it off.
To return the parameters to their default settings
Press [Unity].
Status Menu
You can view the DME operating status in the Status
menu.
Viewing the DME operating status
Open the Status >DME Status menu (3311).
Router Control Menu
Operations
You can control router switching in the Router Control
menu.
Checking the List of Inputs for Each
Destination
Open the Router >Router Control >Router Control menu
(5111).
A list of destination assignments appears on the left side of
the status area.
If in the Engineering Setup >Panel >Router Remote >RTR
Mode Setting menu (7323.1), [Inhibit] is set to On for a
destination, the corresponding line appears in gray. Also,
if [PROT] (protect) is set to ON for a source, using a BKS-
R3xxx or R1xxx series Router remote control, a padlock
icon appears.
The level assigned to the level selection buttons ([Level 1]
to [Level 4]) in the <Level Button No> group are displayed
on the right side of the status area.
Selecting the level
In the <Level Button No> group at the lower right in the
above illustration, press the level for switching.
DME status display
For each DME channel, you can see how the DME is being
used in the corresponding operation block.
The display background color also indicates the following
differences in the way a DME is being used.
Blue: The DME is currently being used in an operation
other than the final program output.
Red: The DME is currently being used in the final
program output.
Switching the Source for Each
Destination
You can switch the source for each destination with a
menu operation.
For the assignment of destinations and sources to buttons,
use the Engineering Setup >Panel >Router Remote >RTR
Mode Setting menu (7323.1).