Sony MVS-6530 - Kaleidoscope Settings

USO RESTRITO
198
Applying Special Effects (Nonlinear Effect Settings)
No.
Parameter
Adjustment
1
Magnify H
Horizontal magnification ratio
2
Curve H
Horizontal curve ratio
3
Size H
Horizontal size
No.
Parameter
Adjustment
1
H
Horizontal reflection position
2
V
Vertical reflection position
No.
Parameter
Adjustment
1
Magnify V
Vertical magnification ratio
2
Curve V
Vertical curve ratio
3
Size V
Vertical size
Chapter
10
DME
Operations
No.
Parameter
Adjustment
1
H
Horizontal original image center
position
2
V
Vertical original image center
position
Kaleidoscope Settings
You can set the number of blocks, the partition reference
point and angle, horizontal and vertical offsets, a reflection
position, and other parameters.
Applying the Kaleidoscope effect
In the Non Linear >Kaleidoscope menu (4141.15), set the
following parameters.
No.
Parameter
Adjustment
1
Number
Number of blocks
2
Phase
Angle of partition reference point
3
Offset H
Amount of horizontal offset
4
Offset V
Amount of vertical offset
To reflect the kaleidoscope image as if in a mirror
1 To reflect in the horizontal direction, press [Mirror H],
turning it on.
2 To reflect in the vertical direction, press [Mirror V],
turning it on.
To set the reflection position
1 Press [Position], turning it on.
2 Set the following parameters.
Applying the Lens effect
1 In the <Mode> group of the Non Linear >Lens menu
(4141.16), select the lens shape.
Circle
Rectangle
Star
Heart
Bar
Cross
2 Depending on the selected lens shape, set the
following parameters.
When Circle, Rectangle, Star, or Heart is selected
No.
Parameter
Adjustment
1
Magnify H
Magnification ratio
2
Curve H
Curve ratio
3
Size H
Size
4
Angle
Slant angle
5
Aspect
Aspect ratio
When Bar is selected
No.
Parameter
Adjustment
1
Magnify H
Magnification ratio
2
Curve H
Curve ratio
3
Size H
Size
4
Angle
Slant angle
When Cross is selected
Parameter group [1/2]
Parameter group [2/2]
To cyclically repeat part of the original and its
reflection
Press [Cyclic], turning it on.
To make only the lens part visible
Lens Settings
You can set the shape and aspect ratio of the lens, the
angle, the magnification ratio, the curve ratio, the size, the
center position, and other parameters.
You can also choose to display only the portion of the
image that is seen through the lens.
Press [Lens Only], turning it on.
The parts of the image outside the lens are removed.
To set the lens center position
1 Press [Position], turning it on.