Sony MVS-6530 - Metal Settings

USO RESTRITO
188
Applying Special Effects (Overall Signal Effects)
No.
Parameter
Adjustment
1
Mix Ratio
Mix amount for Metal video and
input video
2
Y Clip
Clip level of input signal Y level
3
Y Gain
Amount of gain for clip adjusted
input signal Y level
4
Y Offset
Offset added to clip and gain
adjusted input Y signal
No.
Parameter
Adjustment
2
Saturation
Saturation
3
Hue
Hue
No.
Parameter
Adjustment
1
Clip
Reference level for highlight
detection
2
Gain
Amount of gain for highlights
Chapter
10
DME
Operations
Metal Settings
Applying the Metal effect
1 Open the DME >Enhanced Video Modify >Metal
menu (4172).
2 Press [Metal], turning it on.
3 Set the following parameters.
4 In the <Metal Mode> group, select the type of metallic
gloss.
Gold: Give a gold gloss to the input video.
Silver: Give a silver gloss to the input video.
Rainbow: Give a rainbow color gloss to the input
video.
Variable: Give a metallic gloss to the input video in a
parameter adjusted color. The following
parameters can be adjusted.
To mask the Metal effect with a selected pattern
Press [Mask] to display the Mask menu (4127)
( 1 p. 189), and set the pattern type and modifiers.
No.
Parameter
Adjustment
1
Start
Point where dimming starts (dim
start point)
2
Gain
Degree of dimming
4 Press [Flat Color] and set the parameters for the color
of the depths of the picture.
No.
Parameter
Adjustment
1
Luminance
Luminance
2
Saturation
Saturation
3
Hue
Hue
Applying the Fade effect
1 Open the DME >Enhanced Video Modify >Dim &
Fade menu (4173).
2 Press [Fade], turning it on.
3 Set the following parameters.
No.
Parameter
Adjustment
1
Start
Point where fading starts (fade
start point)
2
Gain
Degree of fading
Glow Settings
Applying the Glow effect
1 Open the DME >Enhanced Video Modify >Glow
menu (4174).
2 Press [Glow], turning it on.
Dim and Fade Settings
Notes
The dim and fade functions are not supported by the MKS-
6570 or MVE-8000A.
Applying the Dim effect
1 Open the DME >Enhanced Video Modify >Dim &
Fade menu (4173).
2 Press [Dim], turning it on.
3 Set the following parameters.
Notes
• On the MVE-9000, the Key Border and Glow effects
cannot be turned on at the same time. Only the one
most recently turned on is effective.
• On the MKS-6570 and MVE-8000A, the Defocus
and Glow effects or the Blur and Glow effects
cannot be turned on at the same time. Only the one
most recently turned on is effective.
3 Set the following parameters.