Sony MVS-6530 - Deleting Parallel Tally Settings

USO RESTRITO
Serial Tally Settings 377
Chapter
22
Router
Interface
and
Tally
Setup
6 When setting the tally type, set the following
parameter.
No.
Parameter
Adjustment
3
Type
Tally type
a) 1:R1, 2:G1, 3:R2, 4:G2, 5:R3, 6:G3, 7:R4, 8:G4, 9:R5, 10:G5, 11:R6,
12:G6, 13:R7, 14:G7, 15:R8, and 16:G8 (R is an abbreviation of
“Red Tally,” and G of “Green Tally”).
7 Press [Execute].
Deleting Parallel Tally Settings
1 In the Engineering Setup >Router/Tally >Parallel
Tally menu (7366), select the parallel tally.
2 Press [Clear].
Serial Tally Settings
Making Serial Tally Source Address
Settings
To set the serial tally source address for each port, use the
following procedure.
1 Open the Engineering Setup >Router/Tally >Serial
Tally >Source Assign menu (7367.1).
2 In the<Serial Tally Port> group, select the port to
which the setting applies.
3 Select the bit number of the port.
4 Select the source address.
No.
Parameter
Adjustment
2
Source Addr
Source address selection
5 Press [Source Address Set].
Clearing a source address setting
This sets the serial tally settings, including tally type and
source address for each serial tally port.
To clear a source address setting for a particular
bit
In the Source Assign menu, select the serial tally port and
bit number (see steps 2 and 3 above), then press [Clear].
Setting or Changing Serial Tally
Settings
1 In the <Serial Tally Port> group of the Engineering
Setup >Router/Tally >Serial Tally menu (7367), select
the port to which the setting applies.
2 In the <Tally Group> group, select the tally group.
3 In the <Tally Type> group, press the tally types to
select (you can select up to four).
To clear all source address settings
In the Source Assign menu, select the serial tally port, then
press [All Clear].
Check the message, then press [Yes].
To restore all source address settings to default
values
In the Source Assign menu, select the serial tally port, and
press [Default Recall].
Check the message, then press [Yes].
Notes
The selectable tally types depend on the settings in
step 2.
4 In the <Tally Data Size> group, press one of the
following to select the data size.
128 Bit: 128 bits
256 Bit: 256 bits