Sony MVS-6530 - Rear Panel

USO RESTRITO
54
Power Supply and Connectors
Chapter
2
Names
and
Functions
of
Parts
Rear panel
MVS-6520, MVS-3000A, and MVS-3000
o PRIMARY INPUTS 1 to 32 connectors
n OUTPUTS 1 to 16 connectors
m SERIAL TALLY connector
l TALLY/GPI IN 1 to 18 and TALLY/
GPI OUT 1 to 48 connectors
k REF INPUT connectors
j UTIL (SW) connector
i MVS connector
h REMOTE S1 and S2 connectors
a - AC IN A and B connectors
b U terminal
c REMOTE 1 to 4 connectors
d FM DEVICE connector
e S-BUS connector
f UTIL (FM) connector
g UTIL (SCU) connector
MVS-6530
o PRIMARY INPUTS 1 to 48 connectors
n OUTPUTS 1 to 32 connectors
m SERIAL TALLY connector
l TALLY/GPI IN 1 to 18 and TALLY/
GPI OUT 1 to 48 connectors
k REF INPUT connectors
j UTIL (SW) connector
i MVS connector
h REMOTE S1 and S2 connectors
a - AC IN A and B connectors
b U terminal
c REMOTE 1 to 4 connectors
d FM DEVICE connector
e S-BUS connector
f UTIL (FM) connector
g UTIL (SCU) connector
a - AC IN (AC power input) A and B connectors
(3-pin)
Connect to 100 V to 240 V AC power supply with the
optional AC power cords.
The unit is equipped with two power supplies. When A or
B power supply is connected, unit operation can proceed.
b U (signal ground) terminal
Connect to the system ground.
c REMOTE 1 to 4 connectors (D-sub 9-pin, RS-
422A)
Connect devices supporting Sony 9-pin VTR, VDCP
(Video Disk Communications Protocol), or P-Bus
(Peripheral II Protocol) protocols.
d FM (frame memory) DEVICE connector (USB 2.0
compliant)
This connector is for attaching an external HDD for frame
memory.
1)
e S-BUS connector (BNC-type)
Connect this connector with a BNC cable to an S-Bus data
link via a T bridge.
Connecting devices such as IXS series routing switchers
and MKS-8080/8082 AUX bus remote panels via an S-Bus
data link enables the following kinds of control.
• Returning to the S-Bus, tally data created by this unit on
the basis of data received from other devices
• Switching the cross-points of a routing switcher from the
control panel
• Switching the cross-points of a switcher from the remote
panel
• Displaying on the control panel source names set on a
routing switcher
f UTIL (FM) (utility (frame memory data))
connector (RJ-45 compliant)
Intended for future expansion.
g UTIL (SCU) (utility (SCU)) connector (RJ-45
compliant)
Intended for future expansion.
h REMOTE S1 and S2 connectors (D-sub 9-pin, RS-
422A compliant)
These connectors are used to operate the MVS system
from external devices.