Creating and Editing Keyframes
Selection screen for regions assigned to region
selection buttons
Selection screen for regions assigned to buttons in
the memory recall section
Depending on the region selection state, the following
indications appear.
Green text: Indicates that the assigned regions include
the reference region.
Orange text: Indicates that one of the assigned
regions is selected.
White text: Indicates that no assigned region is
selected.
When any one or more of the regions assigned to the
region selection buttons is not selected, a red bar
appears within the button indication.
2
Press a button indication on the left of the status area,
to select the button you want to assign.
The regions currently assigned to the button you
pressed appear on the right side of the status area.
3
In the <Region Select> group, press the button for the
region you want to select, turning it on.
4
In the <Ref Region Select> group, press the button
indication you want to make the reference region.
The button you pressed lights green.
Specifying an Edit Point
Use one of the following operations in the Flexi Pad.
For details about Flexi Pad operations,
1
“Keyframe
Creation and Editing in the Flexi Pad” (p. 250).
•
To move the edit point to the keyframe immediately after
the current time (the position at which the effect is
currently stopped), press the [>> NEXT] button.
•
To move the edit point to the keyframe immediately
before the current time, press the [<< PREV] button.
•
To move the edit point to a keyframe specified by
number, press the [GOTO KF] button, then enter the
keyframe number with the numeric keypad, and press
the [ENTR] button to confirm.
•
To move the edit point to a specified timecode, press the
[GOTO TC] button, then enter the timecode value, and
press the [ENTR] button to confirm.
To enter a difference value
When moving to a point specified with the [GOTO KF]
button or [GOTO TC] button, you can also enter the
difference from the current keyframe number or timecode
value.
Press the [+/–] button, and enter the difference, then press
the [TRIM] button. Each time you press the [+/–] button, it
toggles between plus (+) and minus (–).
Creating and Editing
Keyframes
Keyframe Creation and Editing in the
Flexi Pad
In the Flexi Pad, press the [EFF] button to switch to effect
operation mode, then press the [EDIT ENBL] button.
The [EDIT ENBL] button lights up, and the memory recall
section switches to effect editing mode.
To Next Page
Loading...
